Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

Reasons for the blockage of rubber tire recycling machine equipment

The clogging of waste tire recycling machine equipment is the first problem often encountered in the use of crushers. The key is the following three reasons:

1. The feed rate is too fast and the load is increased to cause blockage: When feeding the waste tire recycling line, you must pay attention to the current meter. If the offset angle of the needle is too large and exceeds the rated voltage, this indicates that the motor is loaded. If the load time is too long, it will be damaged. In this case, the raw material door must be lowered or closed immediately, so that the feeding method can be changed, and the feeding amount can be adjusted and manipulated according to the total number of feeding feeders. There are two types of feeders for rubber crushing equipment: manual and fully automatic. The customer must select a suitable feeder according to the specific situation. Because the rubber crushing equipment has a high-speed ratio, a large load, and a large load fluctuation. According to this standard, in order to ensure that the speed ratio of the rubber crushing equipment is too fast, the current during the operation period of the rubber crushing equipment is generally manipulated at about 85% of the rated voltage.

2. The feed pipe of the tire recycling machine equipment is not smooth or blocked. Too fast feeding will also block the air outlet of the rubber crushing equipment; this situation is the same as the wrong pairing of the transportation equipment, which will cause the wind in the sewage pipe to decrease Or completely blocked after no wind. After discovering the problem, the first thing to do is to clear the input port, replace the mismatched feeding equipment, adjust the feeding rate, and ensure the normal operation of all machinery and equipment.

Third, the hammerhead is broken, aging, the round hole screen is closed, outdated, and the water content of the crushed raw materials is exchanged, which will block the rubber crushing equipment. In order to ensure that the waste tire shredder for sale is not easy to be blocked, the damaged hammers will be replaced on time to maintain the good operation of the tire recycling machine equipment. In addition, the stainless steel screen should be checked frequently. It's actually not very difficult. It is to ensure that the rubber crushing equipment can make full use of its high efficiency in the whole process of operation. In addition, the requirement for crushed raw materials is that their moisture content should not exceed 14%. This not only improves production efficiency but also prevents the crusher from clogging and improves the credibility of the operation of the rubber crushing equipment.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com