Double shaft tire shredder

1. When the installed power of the main machine is 75+75kw, and the output size is 50-80mm rubber block, the output can reach 7 tons/hour,

2. The optimal design of the knife hook and the feed hopper of the knife holder. After the tire enters the feed hopper, it stands upright on the cutter, and the knife hook of the knife holder will bring the tire into the cutter as soon as possible to crush, shortening the tire on the cutter The residence time, increase the output,

3. The cutter is designed as a double-row detachable type. When the left edge of a row of cutters wears, it can be replaced by another row of the seat. The right edge of the cutter is used to crush the material, which increases the service life of the cutter. 2 times,

4. The cutter is designed to be a detachable small-size cutter, the cost of the cutter is low, and it is about 15-20 yuan to process one ton of tire consumables

5. A knife holder with a knife hook is designed, and the knife hook part can bring the tire into the knife for crushing, and because the knife hook itself only participates in very little shear, the knife hook part is less worn and the load Lower.