Recycling steps of waste tyre recycling machine 

 

Step 1: Crush in advance

The super tire cutter can process the tires of finished cars and trucks into 30-500 mm scrap. This is a low-speed high-speed dual-shaft shredder. Crimped tires do not require special treatment before.

Step 2: Second shred

This file is a granulation which makes the (30-500) mm of waste material in the super tire cutter enter the inside and then becomes 12 mm, which reduces the cycle time. Chips are used in pelletizing equipment to further process tire-derived fuel.

Step 3: Steel wire separation

The magnet was selected from 12mm rubber shavings. Most of the steel was removed, and the chips came from steel. This machine is equipped with rare earth ferromagnetic rollers to ensure a longer performance and practical cycle.

Step 4: Fine granulation

The fine granulation machine ensures that the rubber granulation becomes fine granulation. This machine is equipped with interchangeable screen sizes to determine the actual output size. If the user wants to change the output size, only needs to change the screen.

Step 5: Fabric separator

This shaking table is a fabric separator. The rubber particles and fabric will be separated into different directions. The 75-85 fabric is removed at this step. The mixed rubber particles and the remaining fabric will be transported to the ZZ separator. 

Step 6: Fine separator

The ZZ separator will remove the remaining fabric; the ferromagnetic roller removes the very fine steel in the separator; the system includes an efficient dust removal center. The combination of these devices provides a high-quality rubber granulation with a purity of 99.9.