Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
The quality of the shredder cutter is determined by his blade. The quality of the blade is determined by its material. The material used to make the wood shredder blade is determined according to the material needed to shred the product.
The blade of waste tire granulator machine has three kinds of common processing, multi-blade structure, and spiral surface structure. These three feeding methods have oblique feeding and flat feeding. Flat logs are generally used for long logs, and diagonal logs are generally used for short logs and veneers.
When we feed to the feeding port, we should check whether there is scrap metal or other hard materials in the shredded materials. If it does, it should be cleaned to avoid the collapse of the shredder blades during shredding. Also, check whether there are blades that are about to fall out of the wood shredder blade set before work every day. Replace in time. Because the blades are damaged, you don't know when they will fall off. If they fall in the material box, it will cause all the blades to be reimbursed. In severe cases, it can also cause injury or death to the operator.
Before starting, check whether the rotor of the blade is flexible and reliable, and then turn the wheel by hand. The direction of rotation of the wheel is the same as the direction of the arrow of the machine. Is there any collision in the crushing room? Is the blade of the power machine and shredder lubricated well? During work, pay attention to the operation of the blade of the shredder at any time. If there are noises, vibrations, the excessive temperature of the bearings and the body, and spraying outwards, you must shut down and check-in time. After the shredder is started, let it idle for two minutes to ensure that the motor starts normally. In the feeding process, try to keep it as uniform as possible to avoid excessive load on the equipment caused by concentrated feeding.