Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
How to control the production of tire shredder equipment in the production process? Yuxi Machinery introduces to you:
I. After the tire recycling machine is started, check the ammeter pointer. After the large value of the ammeter pointer returns to a small value, start feeding without any abnormalities. Each startup method must ensure that the current of the tire recycling machine is stable after the main machine is switched.
2, gradually increase the feeding amount according to the main motor current until the main motor current reaches and stabilizes at 85% -95% of the rated value
3. Pay attention to the current change at any time during the shredding process, adjust the feeding amount in time to ensure the load;
4. During the operation, the warehouse inspector checks the granularity of the shredded material at any time. If there is any abnormality, the inspection will be stopped.
5. It is strictly forbidden to climb up the shredding device body during the shredding process;
6. In the normal production process, do not open the belt protective cover to prevent accidents;
7. If abnormal noise or severe vibration is found during work, stop feeding, cut off the power, press the emergency stop switch of the tire recycling machine, check after the rotor has stopped safely, remove the fault, and pull out the emergency stop switch when restarting;
8. If the material is changed and crushed, the material in the tire recycling machine must be exhausted and the batching bin must be replaced before the material can be crushed again.
9., it is required that the moisture of the material does not exceed 10%.