Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

When testing a waste tire shredder machine, you need to drain it manually. Usually, it is operated by the manufacturer's technicians. Users can watch feeding methods and tips. Be careful not to approach the feed inlet to prevent affecting the raw material processing. Finished product splash phenomenon. If you check the internal structure of the machine during the tire recycling machine test, you need to wait until the machine is completely processed, cut off the power, and then perform related operations to ensure the safety of the test machine.
If the sharp angle of the hammer becomes dull, you can use it for reverse angle adjustment. If both ends of the hammer are worn, a hammer head should be used. When adjusting or turning the machine head, all hammer strokes should be performed at the same time to maintain the balance of the rotor. The screen should be replaced when it is worn or damaged. When installing the screen, the burr of the screen should be inward, the glossy side should be outward, and the screen and screen frame should be tightly fixed. After each shift, please clean the inside and outside of the machine and remove the dust to prevent the machine from rusting and blocking the screen and the dust in the bearings. The motor of the tire recycling machine is very important. If the load is too large and the current is too large, it will cause a series of problems. You can check the current of the motor to see if it exceeds the rated current. The main component of the tire shredder is not only the blade, but also the motor of the tire shredder. The requirements of the motor are relatively high. If improperly installed, the motor will generate heat, which will affect the operation of the tire recycling machine. Many customers encounter this problem in actual purchases. Wood peeling machine is suitable for peeling of new crops and some hardwoods, as well as peeling of frozen and dried materials.
Tire recycling machine should pay attention to waterproof, how to waterproof and maintain it? Tire shredder and other machinery should pay attention to moisture and water resistance. The machine is made of iron. Iron is very afraid of water. Although there are paints on the surface, but there are many places without paint, pay attention to moisture and water resistance. In the processing of raw materials, we will find that brittle things are easier to shred, more efficient and better quality, but for wet things, such as wood tire recycling machines for wet wood, the efficiency of shredding will be more low. Than dry wood. Because the wet ingredients are more likely to stick together when chopped, there will be resistance, which affects the effect of chopping. Moreover, the long-term treatment of these wet materials will corrode the internal parts of the machine and easily rust, which further affects the processing efficiency. Therefore, two points should be avoided. One is long-term processing of wet and water-containing raw materials, and the other is often wet by rain. Even simple machines in daily life, such as bicycles, can rust and damage for long periods of time on rainy days. Therefore, avoiding water ingress is the basic common sense for maintaining machines.
If it is not used for a long time, it can be applied to key components such as bearings to prevent moisture corrosion in the air. All in all, machine maintenance is a long-term daily task that requires persistence and patience.