Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
The wearable parts in waste tire shredder machine are mainly blades. After a period of use, the blade needs to be replaced in time. This ability ensures the power of the tire shredder. If the blade is not replaced in time, the tire recycling machine will make uneven discharge, which will reduce the output value and affect the quality. Tire shredder blade replacement also has tricks.
Replace the blade of the tire recycling machine to stop and cut off the power. When the blade is not sharp, sharpen it in time. If the blade is not worn, you can use oil stone sharpening. When the wear is large, the flat blade can be ground with a flat grinding wheel, and then sharpened with oil stone. The viewpoint of the blade should be less than 37 °. Cooling fluid should be added when grinding with a grinding wheel to avoid blade annealing. If the blade is severely worn, you need to replace it with a new one, adjust the blade height, the blade edge of the flat blade is exposed to the disk, and after adjusting the vertical height, tighten the knife bolts to prevent blade movement and damage the tire recycling machine.
The adjustment of the fixed knife, the gap between the fixed knife and the movable knife should be adjusted to 1 to 2mm. After replacing the blade, check whether the bolts in each part are tight. If they are loose, tighten them. Roll the pulley by hand. There should be no friction between the machine parts and the case to ensure safety.
After the machine is turned on, the machine can only be fed when the machine reaches normal speed. Do not start with the machine. When starting the machine, do not deepen the inside of the feed port to avoid being injured by the hand. If there is an abnormal sound during the machine, stop the machine to check the fault and avoid damage. Machine.