Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
In some traditional manufacturing industry, for the processing of raw materials is mainly use some traditional methods to carry on the processing, this method is mainly by people with traditional processing methods to deal with the material, it not only in the form of waste and labor cost, and material processing also is likely to reach expected effect. But, at present, some need to shred the material manufacturers will be a large number of purchasing some waste tire shredder machine, tire process the appearance of the machine greatly help producers to reduce their workload, and help the manufacturer in a short time to a greater extent pieces of complete materials and fine processing, have to say tire shredder the emergence of such a machine for manufacturing is very favorable. In the process of production, the basic processing of raw materials is in place to produce better products. Therefore, for some producers who need to finely process raw materials, tire recycling machine will be an option.
Shredding machine
What problems should be paid attention to when starting up tire shredder so as to better ensure the use of tire recycling machine? The following content will be written in detail for you. It can help you to use tire shredder products better and more correctly.
One: turn on the motor. Chamber motor for no-load operation. Observe the operation of various parts of the tire recycling machine. Check that all parts are running normally before carrying out load operation.
Shredding machine
Two: observe whether there are stuck magnetic and friction sound. If any, stop working immediately and check the cause of failure.
Three: the sieve should be installed firmly, sealed, no leakage, the sieve frame should be tightened.
Iv. If abnormal sound, blocked discharge, overheated bearing or motor are found during the working process, stop feeding, stop for inspection and troubleshoot.
Shredding machine
Five: at the end of the work, the machine should be empty for 2-3 minutes, after the material in the machine completely excluded, stop the shredder and fan.
Vi. Safety must be strictly guaranteed in operation. Tire shredder speed is strictly prohibited. Always check the split pin on the pin shaft, and replace it immediately if there is excessive wear or breakage.