Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
In the process of using the tire shredder, some common failures cannot be avoided, and mechanical equipment will have failures, but the design of the tire recycling machine is reasonable and simple. Generally, the failure will not occur, and artificial irregular operations may occur. Cause failures, then we take a look at those failures that can be avoided:
1. The more frequent failure of the waste tire shredder equipment is the jam of the shredder cavity shaft, which causes the belt of the motor to slip. It needs to be stopped and reversed to remove the fault. Now the new type of equipment has added the function of overload composite automatic reverse . However, if the phenomenon of reversal often occurs, it will greatly affect the progress of production and lead to a reduction in production volume. The solution to this phenomenon is relatively simple, but it also requires patience, that is, it needs to be fed uniformly. The purpose of doing this is to make the shredder's rotating shaft work uniformly, and it will not cause the rotating shaft due to the high and low power requirements. , Reducer, motor speed is uneven, premature aging damage.
2. During the blanking process, the selection of materials with high hardness is required. The blade design of the shredder is for thin and light materials, so the material hardness of the shredder blade is also standard. Therefore, during the cutting process, it is necessary to pick out materials with higher hardness, such as bearing steel, chain and other materials. The high hardness of various types of materials will cause damage to the shredder blades. If these types of materials are shredded for a long time, the shredder blades may be scrapped prematurely, and it is more expensive to replace the new blades.
3. Regularly perform maintenance on the tire recycling machine. The maintenance work of tire recycling machine is relatively simple. Because the shredder has a simple structure, its maintenance work is to regularly fill the bearing with lubricating oil. Do not use a slightly lubricating oil, which will accelerate the damage of the bearing; the transmission oil also requires Periodic inspection, replacement or addition according to the level of lubrication. This will ensure that no mechanical failure occurs during the operation of the tire shredder.
When using a tire recycling machine to perform operations, no special person is required to perform inspections and maintenance. Just paying attention to the above points can reduce the number of times of equipment maintenance and improve production efficiency.