Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
Regarding the materials with surrounding and adhesion properties, we can slow down the cutter speed, such as shredding woven bags, waste wires and cables, etc. Immediately adjusting the test speed of the cutter on the waste tire shredder equipment can increase the bite strength and full tear Shred, you can also shred these wrapping materials as fast as possible. Adjusting the rotation speed of the tire shredder tool according to different materials is based on it. Sometimes it can increase the output value, prevent unnecessary wear of the tool, and extend the life of the tire recycling machine.
The reason analysis suggests that the high temperature of the tire recycling machine rotor bearing may have the following aspects: The bearing gap is too small, which makes the bearing temperature too high. Improper selection of lubricating oil quality, excessive or low viscosity forms an oil film, which can cause the bearing temperature to rise too high. Especially when the viscosity of the oil is large, it not only increases the internal friction between the lubricant molecules, but also increases the friction between the oil and the metal, which causes excessive heat.
Improper installation, the rubber plate and the rubber plate are too thick one after the other, the stiffness is too large, and the deflection is not enough, resulting in bearing competition, fierce friction, and excessive heat. The amount of oil is too large, reaches or exceeds the center of the bottom ball or roller, does not meet the requirements of oil bath lubricated rolling bearings, and is too hot during constant stirring. Because there is no heat in the shell, the heat cannot be released in time and cannot be balanced at the required temperature. Therefore, the rotor bearing temperature is high.