Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
The hammer device and placement method of the tire recycling machine are very particular. When the hammer is very worn, the user needs to replace the hammer. It is easy to disassemble, but what should be paid attention to when installing the device?
First of all, let's understand the placement and density of the hammer:
The placement method of the hammer pieces on the rotor is related to the balance of the rotor, the distribution of materials in the crushing chamber, and the uniformity of the wear of the hammer pieces.
The distribution of tire recycling machine hammers is related to power consumption and power. If the density is too large, the rotor will have a large torque, a large number of impacts, and a large unit power consumption. If the density is too small, the crushing power may be reduced. It is necessary to reasonably test it Determine the density of the hammer.
The requirements for the placement of the tire recycling machine hammers are: the movement of the hammers should not be repeated as much as possible, and the movement of the hammers should be distributed uniformly along the operating width of the crushing chamber. The material is not discharged to an example, which is beneficial to the dynamic balance of the rotor.
Yuxi Machinery Equipment Co., Ltd. ’s tire shredder hammer placement method is a more reasonable method adopted through repeated tests and based on user feedback. When replacing the hammer piece, the user must remove the replacement in full. You cannot see which wear is severely changed. This will affect the dynamic balance of the waste tire shredder, which is prone to unexpected accidents and even damage the machine.
The orientation of the hammer blade on the pin is also basically fixed. When replacing, do not change it at will.