Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

The waste tire shredder machine is a heavy machine that can shatter and tear materials. The working environment of the device is very bad.
  First of all, the operating speed of the tire recycling machine reducer is -10c ~ 40c, which may cause damage to the reducer.
  Do not use a high-pressure water gun to break the shredder reducer to prevent damage.
  When appropriate, oil should be used to protect the gearbox.
  The tire recycling machine blade is an important part of the tire recycling machine. If worn or dull, it must be repaired or replaced in a timely manner. The tire shredder's claws must be repaired in time and usually proceed. Inspect and maintain tire shredder blades. The production of tire shredder uses a unique hydraulic sliding design to make operation safer and more convenient.
  First, the inspection of the tire recycling machine is stricter:
  1. Multi-point dry oil pump and its pipeline supply.
  2. Whether the wedge-shaped adjustment position meets the design technical requirements.
  3. Observe if there are contact positions between the cards.
  4. Confirm the direction of rotation. Why does the motor run for 2 hours at no load and check the bearing temperature?
  5. Keep the flywheel away from the dead point to overcome the inertia at startup.
  6. Install the V-belt and adjust the tension and parallelism between the two wheels.
  7. Before starting the grinder, the dry oil pump must be started to refuel the lubrication point.
  8. No-load test runs for 4 hours. When the shredder is running, it should meet the following requirements:
  9. There should be no abnormal noise between the bracket and the bracket.
  10. There should be no excessive noise between the locking spring and the drawbar.
  11. The temperature rise of the bearing shall not exceed 30 ° C, and there shall be no abnormal fluctuation. .

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com