Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

The inspection and maintenance of the new waste tire shredder machine should include: adjusting the gap between the shredder's rotor and the impact liner, replacing the wearing parts in a timely manner, and regularly checking the temperature of the hammer, liner and bearing. When the rotor of the new tire shredder is running, the gap between the rotor and the impact liner cannot be adjusted. If the material stays between the impact plate and the shell, it is recommended to re-adjust the gap to slightly raise the impact frame, so that the block feed will become loose and the impact frame is easy to adjust. If the counterattack is not enough, you can pat it on the loosened rod (protected with a wooden board). The gap between the rotor and the counterliner is completed by the adjustment device of the machine. First, loosen the bolt sleeve, and then turn the long nut. The pull rod will move upwards and adjust to tighten the screw sleeve.
When replacing consumables, first open the rack. When in use, first remove the connecting bolts between the rear rack and the middle box, then use a wrench to screw to the hex head of the flip device, and then open the rack slowly. At the same time, you can use the hanging device above the rack to suspend it to the rear rack. Repeat the process to close the shelves. When the new-type tire recycling machine is worn to a certain extent, it should be adjusted or replaced in time to avoid damage to fasteners and other components. Open the upper back cover and remove the cotter pins, slotted nuts, and bolts used to fix the backing lining. The worn back lining can be replaced. If installing a new strike liner, reverse the above steps immediately. In addition, during normal operation, the bearing temperature of the shredder should be checked in time. If there is an abnormality, it is likely that the grease is too much and insufficient, or the grease is dirty, or the bearing is damaged. In this case, it should be timely Check the amount of grease, or replace grease, bearings, etc.
Yuxi Machinery's new tire recycling machine is a multi-purpose device. The new tire recycling machine uses traditional technology as the technical guide. It recycles waste materials through integrated one-time shredding operations, and customizes production according to customer's production needs. Reasonable cost-effective.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com