Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

3. It is necessary to remove debris on the spindle and flange before the tire recycling machine blade device. The appearance of the flange should be flat, clean and the shafts intersect each other straight.
    4. Using a flange as large as possible can make the operation of the saw blade more stable. The thickness of the flange must be the same. The thickness of the flange is 1/3 of the diameter of the blade. (Thin saw blades should use 1 / 2D flanges. ) Better sawing effect (especially for thin blades).
    5. The tire recycling machine blade should idle for 30 seconds after the device is stable, and then start cutting after determining that everything is normal.
    6. When the waste tire shredder machine blade is installed, the flange nut must be tight and moderate. The over-loose saw blade will slip during rotary cutting. The over-tight saw blade will have internal injuries or deformation affecting the cutting effect.
    It should be specially noted that the safety of the use of the tire recycling machine is the top priority of enterprise development. Operators of the tire shredder must bring protective gear (protective glasses, dust masks, hard hats, protective gloves) and check whether the protective cover is sufficient.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com