Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

The waste tire shredder machine consists of the main structure of the motor, reducer, rotary cutter shaft, imported moving knife, fixed knife, frame, base, and box. Through continuous improvement, tire shredder has successfully developed a large-scale automatic shredder unit with high automation and high production efficiency. Tire recycling machine should be developed in the direction of intelligence in response to market demand.
During the long-term production of the tire recycling machine, different degrees of component wear occur, resulting in a decrease in production efficiency or a failure. Zhengzhou Yuxi Machinery gives you an analysis of the causes of the liner detachment that is common in the production process of the tire recycling machine:
1. The sliding groove of the lining seat and the base is worn. The asymmetry caused by the arc depression state causes the lining plate seat to be non-parallel in the groove, and the phenomenon of falling off occurs. At this time, it is necessary to make the lining plate seat cooperate with the chute to repair the work, and ensure that the half-seat seat moves in parallel in the groove.
2, the welding sliders on the machine base wear uneven thickness. The measured error is caused, so that the contact between the adjusting wedge and the base is not vertical, causing the lining to fall off. In this case, the base slider should be repaired to ensure that it can rise or fall vertically with the lining seat.
3, the tie rod is damaged or the nut is released. It is necessary to replace the tie rod and retighten the nut of the tie rod.
4. The hardness or toughness of the crushed material is outside the specified range. In this case, the broken material that does not meet the specifications should be cleaned out.
5. The motor wiring position is reversed. Connect the motor wiring position of the tire recycling machine correctly.
6. The lining plate is displaced. The position of the lining should be adjusted in time.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com