Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

With the rise of environmental protection equipment in China, there is already a large market. China is a big country in the use and sale of tires. What is the specific utilization status? How to effectively recycle used tires? Waste tires are highly resistant to heat and machinery and are difficult to degrade. It will not disappear naturally for decades, long-term open-air stacking, occupying a large amount of land, and it is easy to cause fires. How to recycle these used tires and make good use of them makes us face a problem. On this basis, manufacturers are constantly developing. Created a waste tire shredder machine.
In a tire recycling machine, each component has its own function. One of the components is the spindle. The spindle of the tire shredder is proofed before production. The direct benefit of this is that it is easier to operate the device.
The role of the spindle in the tire recycling machine is very important. After using the tire shredder for a period of time, the spindle will shift to a different extent or the vacancy or even the tortuosity. The spindle twist will not only affect the service life of the bearing. It will also bring a lot of problems to the work of the tire shredder. The twists and turns of the spindle may cause the blades to dry and sexually cut each other, causing the blades to unnaturally wear out, seriously affecting the service life of the blades and affecting the materials. The processing of the standard vertebrae, assuming that the tire recycling machine is selected by the direct connection of the reducer, will also reduce the life of the reducer, the use of the belt drive will be a very simple attack band, and then reduce the life of the V-belt, so To proofread the spindle of the tire shredder.
The calibration requirements for the tire recycling machine spindle use the press, four-jaw chuck, base support, etc. The proofreading method for the spindle is as follows:
1. Using the press to calibrate the fourth section of the main shaft, first use the four-jaw chuck to clamp the fifth section, select the base frame support structure to support the third section, and find the fourth section of the base.
2, followed by the base eye, then use the thimble to hold the base frame, the first section of the fine car, the third section, some rough car vacancies.
3. The spindle is changed by the head. The four-claw chuck is used to clamp the first section of the list. The base frame support structure is used to support the fifth section, and the fourth section is corrected. Hit the base eye, then use the thimble to withstand, remove the base frame, the fifth section of the fine car, the rough car vacancy.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com