Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
Tire recycling machine rotor bearing high temperature may have the following aspects:
bearing clearance is too small, resulting in too high bearing temperature.
Improper choice of lubricating oil brand, too much viscosity or too low viscosity to form oil film, can lead to the bearing temperature rise too high.
Especially when the oil viscosity is larger, it not only increases the internal friction between lubricating oil molecules but also increases the friction between oil and metal, resulting in excessive heat. The fifth segment is clamped by four-jaw chuck, the third segment is supported by the base frame support structure, and the fourth segment is aligned. Base eyes, and then use a thimble to support, remove the base frame, fine car-top section, the third section, rough car space some.
Do not increase at will when the tire shredder is working, the temperature of the bearing should not exceed 40℃. If the temperature of the bearing continues to rise under normal working conditions, the clause shall be found and the fault shall be eliminated.Speed of tyre shredder. Generally speaking, the difference between the speed and the rated speed is 8%-10%.Shred machine in large power machine work, should pay attention to control the flow, make the flow even so that it can not suddenly accelerate or slow down. In the structure of tyre recycling machine equipment, it is necessary to replace the old tire shredder and damaged equipment in time, which will greatly improve the utilization rate. At the same time, the waste tire recycling plant will be set up to synchronize the automatic management, which will not only save time but also benefit the production of tyre shredder plant.