Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
In the work of the waste tire shredder machine, there are many faults in the daily shredder. Among them, the motor failure or the motor burning is a serious loss.
How to ensure the normal operation of the tire shredder motor and avoid the motor failure caused by overload and short circuit?
1. Set motor short circuit protection
Any power supply line must be equipped with a current protection device. When there is a short circuit in the tire shredder, if there is no short circuit protection mechanism, it will directly cause the motor to burn out in a short time.
2. Set motor overheat protection
For motors larger than 0.5kW, the motor overheat protection system needs to be configured to prevent the motor from working for a long time or for a long time to cause the motor to heat up and burn the motor insulation layer, causing the motor to burn out.
3. Ensure the cleaning of the tyre shredder motor
The environment around the motor should be clean and ventilated. At the same time, the equipment should be cleaned regularly to prevent the dust from accumulating for a long time, damage the insulation of the motor, and cause the motor to short-circuit and burn the motor.
4. Irregularly check whether the bearing and stator of the motor are stuck abnormally
Irregularly check whether the motor bearing is overheated, lack of oil, turn the jam, check whether the motor bearing is damaged, and whether the bearing clearance is too large. If the above problems occur, the bearing should be replaced in time.
5. Observe the motor for abnormal vibration, noise and abnormal odor
If the motor does not vibrate normally and the noise will cause the motor load part to be different, increase the motor load during operation, and burn the motor after a long time of operation. Therefore, it is necessary to regularly check whether the anchor screw, the motor end cover, the bearing gland, etc. are loose during the operation of the motor, and whether the grounding wire is reliable.
The motor odor is the cause of overheating and burning of the motor insulation layer. As soon as this situation is discovered, the power should be cut off immediately to check the motor fault.
The above is the troubleshooting of the motor in the daily work of the tire shredder, regular cleaning, check whether the motor is flexible, and ensure the best working condition of the motor.
Zhengzhou Yuxi Machinery Factory specializes in the production of tire shredders and tire recycling plant and other equipment, customers are welcome to inquire at any time.