Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
1. Because of the high working strength of the bearing, the waste tire shredder bearing should be replaced regularly and at the same time ensure the normal use of the shredder bearing during the bearing replacement cycle.
At the same time, all maintenance work of the bearing must be recorded as the basis for setting the bearing replacement cycle and determining the bearing quality.
2. Regularly inspect the motor and record the motor running condition (motor vibration, motor and bearing temperature, motor running current).
Generally, the two-pole motor of 75KW or more is once a day. Strengthen inspections when abnormal operating conditions occur and record relevant content.
3, bearing and bearing cap refueling: bearing cap oil capacity for bearing cap capacity 1/2 ~ 2 / 3.
4. The motor end cover with oil filling hole and oil drain hole must also be cleaned when changing oil to keep the passage open. The oil hole must be filled with oil when refueling.
5. The motor with the oil filling hole must be replenished regularly. The oil replenishment cycle is determined according to the motor operation requirements and operating conditions (usually 500 hours of bipolar motor operation for 24 hours).
6. When replenishing oil, the oil filling port must be clean. The amount of oil replenishment is limited to the bearing temperature increase of only 2 °C (the 2-pole motor is quickly filled with oil gun for two minutes, depending on the situation, whether to continue adding).
Tire shredder bearing replacement maintenance
1. When the bearing is dismantled for maintenance, the old bearing should be scraped off with scraped bamboo oil, and then the bearing is slowly rotated in the gasoline and carefully cleaned. Then rinse twice with clean gasoline.
2. After the cleaning of the bearing is completed, it should be rotated by hand. It should be flexed by hand with radial and axial movements to judge whether it is loose or the gap is too large. Check the gap if necessary. New bearings should be replaced if the ball or roller frame is severely worn, corroded and metal flaking.
The above is the guide for the maintenance and replacement of the Yuxi tire recycling machine bearings.
Yuxi mechanical tire shredder & tire recycling plant is reliable in quality and strong in stability. It is available from the factory and customers are welcome to inquire.