Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
The normal production of the waste tire shredder machine directly affects the production efficiency of the tyre shredder and the normal operation of the tire recycling plant. Therefore, we must do the daily troubleshooting and repair work of the tyre shredder.
The following are common faults in tire shredders:
(1) Tire shredder motor rotor and gearbox different level
The tire shredder adopts a motor direct drive reduction chassis to drive the rotation mode of the shredder cutter shaft. If the reducer is not in the same direction as the rotor of the motor, the belt of the shredder will be easily detached and the wear will be severe. At the same time, the tire shredder motor and equipment will have vibration and noise as a whole.
Treatment: Move the left and right motor positions or pad under the motor foot to adjust the motor belt tightness and the motor reducer concentricity.
(2) The tire shredder cutter shaft and the reducer rotate differently
The difference between the tire shredder cutter shaft and the reducer chassis can also cause the tire shredder vibration noise and accelerate the wear of the equipment. This problem is generally a manufacturer installation problem in equipment production.
Treatment: Pad copper can be placed on the bottom of the bearing housing, or adjustable wedge iron can be added at the bottom of the bearing to ensure that the shaft head is concentric. In the motor, reducer and cutter shaft, the concentricity of the cutter shaft and the reducer is preferentially adjusted, and then the position of the motor is adjusted to ensure that all three are operated concentrically.
(3) The tire shredder has a poor cutting effect and low production efficiency.
If the tire shredder is produced for a long time, tool wear and damage may occur, and the shredder may be unfavorable when the shredder equipment has a high tearing hardness.
Disposal method: disassemble and repair the tool, replace it if necessary, and pay attention to the wear and deformation of the flange.
(4) The tire shredder has more debris in the machine cavity.
If there are too many sundries in the machine cavity of the tire shredder, it will affect the shredder's shredding effect and generate noise.
Treatment: Regularly stop the tire shredder and clean up the shredder machine debris.
In addition to the above problems, the tyre shredder will also have problems such as bearing damage, motor heating, etc.
If problems are found, the shredder equipment operators should timely stop the equipment maintenance, and customers can also contact the waste tire shredder manufacturers at any time -- ---Yuxi Machinery, we are always ready to escort your tire recycling machine production.