Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
Trouble shooting of tire shredder motor overload operation
1. If the waste tyre shredder machine motor is overloaded, consider reducing the motor load or replacing the motor with a higher power.
2. The power supply voltage is unstable, too high or too low, and a three-phase power supply voltage compensation cabinet is required.
3. The motor is heavily wet or corroded by corrosive gases, and the motor's insulation performance is degraded. In this case, you need to repair the motor or replace the closed motor of the same specification.
4. The tyre recycling machine motor bearing is short of oil or damage. Check the motor bearing condition, add lubricant or replace the new bearing.
5. The bearing is not concentric with the rotor of the motor, causing the rotor of the motor to sweep so that the motor current exceeds the rated value. At this point, it is necessary to check the motor bearing and the motor rotor for different reasons. If the center of the end cap is seriously worn, the end cover needs to be repaired.
6. The tire shredder itself has a faulty connection between the gearbox and the motor drive, causing the motor load to be too high. At this time, the motor drive components need to be inspected and repaired.
Waste tire shredder and tire recycling plant manufacturer----Yuxi Machinery to protect the customer's use of tyre recycling machine, installed motor load automatic control instrument, to achieve automatic control of shredder equipment load, energy saving and environmental protection, minimize and eliminate human error, protect the tire shredder for long-term, stable and safe operation.