Products

Waste Rubber Grinding Mill Mach Waste Tire Shredder 4M Waste Tire Tread Cutting Mac 1200mm Tire Cutting Machine Central Dust Collector Tyre Wire Removing Machine 3M Waste Tire Tread Cutting Mac Single Hook Steel Wire Drawing

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

Tyre recycling machine rotor bearing high temperature may have the following aspects:
bearing clearance is too small, resulting in too high bearing temperature.Improper choice of lubricating oil brand, too much viscosity or too low viscosity to form oil film, can lead to the bearing temperature rise too high.

Especially when the oil viscosity is larger, it not only increases the internal friction between lubricating oil molecules, but also increases the friction between oil and metal, resulting in excessive heat.

The fifth segment is clamped by four-jaw chuck, the third segment is supported by base frame support structure, and the fourth segment is aligned.Base eyes, and then use thimble to support, remove the base frame, fine car top section, the third section, rough car space some.

Do not add any material when the machine is working.

The temperature of the bearing should not exceed 40℃.

If the temperature of the bearing continues to rise under normal working conditions, the cause shall be found and the fault shall be eliminated.

Tire shredder machine speed, generally speaking, speed and rated speed difference is 8%-10%.

Shred machine in large power machine work, should pay attention to control the flow, make the flow even, so that it can not suddenly accelerate or slow down.In the structure of the shredder, to replace the old equipment and damaged equipment in a timely manner, will greatly improve the utilization rate, and set up the production line, so that automatic management synchronization, not only save time and conducive to production.

Tire shredder is our company introduce advanced technology research and absorbing and second-generation product.

At the general temperature, can be put directly into the tyre antrum coarse crushing into 50 * 50 mm block, so the next rotating can grind into 10-30 meshes tagma or wire and fiber separation equipment.

We also produces the entire production line for tire recycling machine, namely the tire recycling plant.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com