Products

Tyre Wire Removing Machine Single Hook Steel Wire Drawing Rubber Grinding Machine Tire Shredder 1200mm Tire Cutting Machine Central Dust Collector 3M Waste Tire Tread Cutting Mac 4M Waste Tire Tread Cutting Mac

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

Tire shredder boot step:
1. Start the motor of tyre shredder without any load. If the technical conditions of each part are normal, the load can be run after the speed is normal.
2, running tire recycling plant, there should be no magnetic and friction sound.
3, the sieve should be installed firmly, sealed, no leakage, and the sieve frame should be fastened.
4. If abnormal noise, discharge blockage, bearing or motor overheating are found during the work of tire recycling machine, stop feeding, stop the tre recycling machine and check to eliminate the fault.
5. At the end of the work, it should be run for 2-3 minutes, and the machine can be completely removed before the crusher and fan can be stopped.
6, the operation of the tyre recycling plant must strictly ensure safe production. It is strictly forbidden to increase the speed of the waste tyre shredder machine. Always check the split pin on the pin and replace it if it is excessively worn or cracked.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com