Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
In order to judge whether the removed bearing of waste tire shredder can be reused, it is important to check its dimensional accuracy, rotation accuracy, internal clearance, mating surface, raceway surface, cage and seal. Large bearings of tyre shredder can not be rotated by hand. Pay attention to the appearance of rolling elements, raceway surfaces, cages, ribs, etc. The higher the importance of bearings, the more careful inspection is required.
Rolling bearing of tire recycling machine causes and troubleshooting
Bearing accuracy is low: bearings with specified accuracy grades are selected.
The spindle is bent or the hole in the case is not the same: repair the spindle or the case.
Poor lubrication: Use the specified grade of lubricant and clean it properly.
Low assembly quality: improved assembly quality.
Bearing inner casing running ring: replace the bearing and related wear parts.
The axial force is too large: cleaning and adjusting the gap of the sealing ring is required to be between 0.2 and 0.3 mm, correcting the balance hole diameter of the impeller and verifying the static balance value.
Bearing of tyre recycling machine damage: replace the bearing.
storage
The bearings of tire recycling machine are coated with an appropriate amount of anti-rust oil and packaged with anti-rust paper. As long as the package is not damaged, the quality of the bearing will be guaranteed. However, in the long-term storage, it is recommended to store on a shelf 30cm above the ground under the condition of humidity below 65% and temperature of about 20 °C. In addition, the storage place should avoid direct sunlight or contact with cold walls.