Products

Tyre Wire Removing Machine Single Hook Steel Wire Drawing Rubber Grinding Machine Tire Shredder 1200mm Tire Cutting Machine Central Dust Collector 3M Waste Tire Tread Cutting Mac 4M Waste Tire Tread Cutting Mac

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

The disassembly of the bearing of waste tire shredder machine is carried out on a regular basis and when the bearing is replaced. After disassembly, if you continue to use it, or if you need to check the condition of the bearing, the disassembly should be carried out as carefully as the installation. Be careful not to damage the bearing parts of the tyre shredder, especially the disassembly of the interference fit bearing, which is difficult to operate.
It is also important to design and manufacture disassembly tools as needed. When disassembling, study the disassembly method, sequence, and investigation of the fitting conditions of the bearing of tire recycling machine according to the drawings, so as to obtain the foolproof operation.
To remove the interference fit outer ring of the outer ring, install a few outer ring extrusion screw screws on the circumference of the outer casing, and tighten the screw evenly while disassembling. These screw holes are usually covered with a blind plug, a tapered roller bearing, etc., and a plurality of slits are provided on the shoulder of the outer casing, and the spacer is used, disassembled by a press, or gently tapped and disassembled.
The removal of the inner ring is the easiest to pull out with a press. At this time, pay attention to let the inner ring withstand its pulling force. Moreover, the pull-out fasteners shown are also mostly used, and regardless of the type of fixture, they must be firmly stuck on the side of the inner ring. To do this, consider the size of the shaft shoulder or study the groove at the shoulder to use the pull fixture.
The inner ring of large bearings is dismantled by hydraulic method. The oil pressure is applied to the oil hole of the bearing to make it easy to pull. The bearing with a large width is used in combination with the hydraulic chucking method and the drawing device.
The inner ring of the cylindrical roller bearing of the tyre recycling machine can be removed by induction heating. A method of heating a part in a short time to expand the inner ring and then pull it. In the case where a large number of such bearing inner rings are required to be installed, induction heating is also used.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com