Products

Tyre Wire Removing Machine Single Hook Steel Wire Drawing Rubber Grinding Machine Tire Shredder 1200mm Tire Cutting Machine Central Dust Collector 3M Waste Tire Tread Cutting Mac 4M Waste Tire Tread Cutting Mac

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

When the tire recycling machine screen is seriously worn and needs to be replaced, it is necessary to pay attention to whether the flatness of the new screen and the size of the screen are reasonable, whether the installation is in place, and the surface of the screen is better to face inward when installing;
The opening degree of the impeller feeder to adjust the wind should be adjusted properly;
If it is found that the waste tire shredder machine has abnormal vibration and high noise, it should be stopped immediately;
The spindle bearing of tyre recycling machine should be filled with 80 grams of grease after 40 hours of operation, but only 60%. After 1800 hours of operation, the bearing cover should be removed and all used grease replaced. When replacing the grease, add grease to the area around the roller and the bearing ring, and add 1/3 ~ 1/2 of the grease to the bottom case. Never add too much grease.
When it is found that the tyre shredder output suddenly drops, in addition to the raw material factors, it should be checked whether the air supply port is in place, whether the pipe is leaking, whether the pulse bag is blocked, whether the solenoid valve or the fan is working normally.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com