Products

Tyre Wire Removing Machine Single Hook Steel Wire Drawing Rubber Grinding Machine Tire Shredder 1200mm Tire Cutting Machine Central Dust Collector 3M Waste Tire Tread Cutting Mac 4M Waste Tire Tread Cutting Mac

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

The cracking of the inner shell of the 800 type waste tire shredder will cause the inner shell coarse material to leak into the outer shell, which will make the fineness of the finished product thicker. In this case, if the method of driving into the control panel or increasing the number of auxiliary wind blades is still ineffective, the product fineness is still very thick. When it is time, it should be stopped and checked in time. In the bend of the lower cone discharge pipe, the inner shell is more likely to be worn and damaged. If there is a hole, it can be temporarily welded and repaired.
Wind blades fall off or break:
When the auxiliary blades fall off, the fineness of the product suddenly becomes thicker and fluctuates more. At this point, the shredder body has a lighter swing, and should be shut down and checked in time.
The control panel is not aligned:
In the operation of the Type 800 tire shredder, the control panel may also move inward or outward due to vibration of the body, resulting in a change in product fineness. At this time, it is also necessary to check whether the dimensions of the control panel are uniform, so as to be corrected in time.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com