Products

Tyre Wire Removing Machine Single Hook Steel Wire Drawing Rubber Grinding Machine Tire Shredder 1200mm Tire Cutting Machine Central Dust Collector 3M Waste Tire Tread Cutting Mac 4M Waste Tire Tread Cutting Mac

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

If the tyre shredder tool wears out, replace the tool in time to avoid affecting production efficiency. Only when the tool wear condition is mastered can the tool be made in time.

Then in the process of normal wear and tear, we need to understand the extent of wear, we need to change the tool, the tool is the normal wear and tear with the increase of working time, the general wear is divided into three stages:

       In the first early stage, there were a series of imperfections such as tiny pleats, oxidation or carbon layers due to the rough surface and unevenness of the new tire shredder.

However, the cutting edge of the equipment is very sharp, so the tool wear at this stage is also called the equipment running-in period. Since the performance of the equipment can be maximized after the running-in period is reached, the production value can be maximized, so it is not recommended to change the tool now.

       In the second normal wear stage, when the rough surface of the tool is basically flattened, the tool has begun to wear and wear, but the blade is still very sharp and the degree of wear is slow, so the wear stage is very stable and slow in the normal operation of the equipment.

       In the third most important phase, it is time to pay attention to the wear state of the blade.
If the wear width is extended to a certain limit, the surface roughness of the machined surface becomes thicker, and the wear speed increases rapidly. When the machine is severe, the tool loses the cutting ability. If the efficiency is affected, the tool must be replaced.

       Yuxi tire shredder tool material is made of European imported materials: 9crsi, Cr12MoV, SKD-11, CrNiMo and other high-quality wear-resistant alloy steel forging. All of our machines support specialized and customized services, with a wide range of products, good quality and high output.

Yuxi Machinery Factory has been specialized in the production of waste tire recycling machine and tire recycling plant for many years. It has rich experience, stable equipment and low failure rate. Welcome customers to inquire at any time.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com